Connect your legacy audio gear to the DANTE® world. The Line I/O to DANTE® Interface is an end-of-network device. It is a breakout box which allows two channels of audio to be integrated into a DANTE® network. Simultaneously, NA-2I2O-DLINE converts a DANTE® stream into analog audio signals. Hence, it is possible to use this tiny box to feed analog audio signals into the DANTE® network while at the same time receiving a mix from another DANTE® source.
Features:
Connect analog audio equipment to a Dante® network
Feed non Dante® ready amplifiers, speakers or mixing desks with signals from the Dante® network
AES67 compliant
Improved Audio Parameters
Enhanced ESD Protection
LED Ring for Status Indication
Extremely robust and compact design for rugged stage conditions
Rack mountable
Requires a Power over Ethernet switch or a PoE injector (802.3 af/at; class 1)
Specifications:
Electrical
Power consumption: < 2 watts
Power supply: PoE switch (Power over Ethernet) or PoE injector (according to IEEE 802.3af/at/bt)
Dante specifications
Channels: 2 INPUTS (line level), 2 OUTPUTS (line level)
Supported sampling rates: 44.1 / 48 / 88.2 / 96 kHz
Bit depth: 16, 24 and 32 Bit
Latency: Depending on the network configuration, 1 ms (standard)
Ethernet connection: 100 BASE-TX (PoE support)
Analog audio input
Input impedance: 6.6 kOhm
Input level (balanced): 24 dBu max.
Frequency response: 20 Hz to 20 kHz (+/-0.5 dB)
Dynamic range: > 100 dB
Signal-to-noise ratio: > 108 dB
THD + noise: 0.01 % @ + 4 dBu, A-weighting
Crosstalk: -110 dB @ 20 kHz
Analog audio output
Output impedance: < 150 Ohm
Output level (balanced): 24 dBu max.
Frequency response: 20 Hz to 20 kHz (+/-0.5 dB)
Dynamic range: > 100 dB
Signal-to-noise ratio: > 108 dB
THD + noise: < 0.01 % @ + 4 dBu, A-weighting
Crosstalk: -100 dB @ 20 kHz
